Informationen zu Lieferzeiten – hier ansehen

Erbauer Trocken Diamantfliesenbohrer 44 mm Artikelnummer: 8116T

15,89 €
Lange Lebensdauer, feiner Diamantenschliff für ein professionelles Qualitätsergebnis ohne beschädigte Fließen. Wartungsfreundlich, selbstkühlend und selbstschärfende Körnung. Für trockenes und nasses Schneiden geeignet.
Technische Daten
Zusätzliche Information
Erbauer Trocken Diamantfliesenbohrer 44 mm

Special Price 15,89 €

Statt 31,99 €

Inkl. 19% MwSt. versandkostenfrei

Sie sparen 16,10 € (50%)


Markt wählen

Zum Wunschzettel hinzufügen

* Ausnahmen beachten Details anzeigen

Erbauer Trocken Diamantfliesenbohrer 44 mm wurde bewertet mit 4.8 von 5 von 9.
Rated 5 von 5 von aus Excellent I was really struggling to cut a hole in a tile and had already burnt out or broken several other 'normal' tile drills. Even a full core drill did nothing more than remove the top surface of the tile. However, within 5 minutes of getting back from Screwfix with this bit I had the hole drilled and the fitting in place. This bit just eats through the tile. I just wouldn't mess about with anything else now and will be getting some other sizes to keep in the bag. Some reviewers have mentioned the lack of a guide bit, and this would be helpful in some circumstances, but it's pretty easy to simply start the edge of the drill and then tilt it until the whole bit is cutting. Admittedly, you need, therefore, to mark the circumference of the hole you want to drill but, in many cases, this is easier than marking the centre. The key is to have confidence and keep the drill on full speed.
Veröffentlichungsdatum: 2018-05-02
Rated 5 von 5 von aus Not bad at all Although this bit did not fit into my support, it’s very easy to get it started on the tile if you have it on full speed and just hold it at a slight angle to start you off then straighten it up (I did this after reading a review further down before I bought it and it did work just as he said). So don’t let this not fitting in the support put you off buying it. It cut through the 10mm ceramic floor tiles I was using absolutely effortlessly, 8 holes no water and still going strong for the next job.
Veröffentlichungsdatum: 2018-06-16
Rated 5 von 5 von aus 44mm diamond tile drill Top product I've drilled 30+ holes in porcelain and it's still going strong would definitely recommend this hole saw
Veröffentlichungsdatum: 2016-09-07
Rated 5 von 5 von aus Brilliant drill Bought this after trying some cheaper titan drills from Screwfix which were worse than useless (returned for refund). This drill cut through 10mm porcelain tiles with ease with no signs of wear. You can also enlarge the hole from the 44mm diameter by running the sides of the drill around the edges of the hole, I managed to achieve a neat 55mm diameter hole using this technique. Highly recommend this drill.
Veröffentlichungsdatum: 2017-05-05
Rated 5 von 5 von aus Excellent product I bought this drill bit to cut holes in 10mm porcelain tiles and wasn't sure how it would perform as the last time I used a diamond core drill bit from another supplier it lasted for less than two holes before it was useless. This one however has been a dream to use. No water needed like the last one and I've cut 6 holes and it looks almost as good as when it came out of the packaging.
Veröffentlichungsdatum: 2016-04-27
Rated 5 von 5 von aus Recommend Quiet a pricey outlay for the couple of holes I needed to drill (in tough porcelain tiles) but must say this bit cut through the tiles really well when no other drill bit I had touched them. Used on a wet tile as recommended by other reviewers.
Veröffentlichungsdatum: 2017-11-13
Rated 5 von 5 von aus Works as it should Needed to cut through 10mm glass and it did so in seconds with a battery drill leaving a nice clean cut. A bit pricey for 1 cutting bit but still looks like new so I would say it would do a lot of cutting before needing to be replaced.
Veröffentlichungsdatum: 2016-03-01
Rated 4 von 5 von aus Great Product Great product, cuts through the heavy porcelain tiles with ease. Bought two as thought they wouldnt last but the first one is still cutting.
Veröffentlichungsdatum: 2015-05-22
  • y_2019, m_6, d_18, h_6
  • bvseo_bulk, prod_bvrr, vn_bulk_2.0.12
  • cp_1, bvpage1
  • co_hasreviews, tv_0, tr_9
  • loc_de_DE, sid_8116T, prod, sort_[SortEntry(order=RELEVANCE, direction=DESCENDING)]
  • clientName_screw-fix-de