Black Friday


Erbauer flach Holz Bit Extension 300 mm Artikelnummer: 9185K

2,49 €
¼" Sechskantaufnahme. Für schnelle akkurate Schnitte.
Technische Daten
Zusätzliche Information
Erbauer flach Holz Bit Extension 300 mm

Special Price 2,49 €

Statt 4,99 €

Inkl. 19% MwSt., (zzgl. 4,95 € Versand)

Sie sparen 2,50 € (50%)


Markt wählen

Zum Wunschzettel hinzufügen

* Ausnahmen beachten Details anzeigen

Erbauer flach Holz Bit Extension 300 mm wurde bewertet mit 4.1 von 5 von 39.
Rated 5 von 5 von aus Great for those noggins I bought three of these combined with a long wood bit to get through a noggin halfway down a partition wall. Thing to remember is to allow for the overlap. So with all four bits combined my overall length was approx. 112cm. I recommend gaffer tape on the joins if you're drilling down from the top. You don't want any vibration loosening the grub screws and the whole thing dropping down inside your wall!
Veröffentlichungsdatum: 2018-03-12
Rated 5 von 5 von aus A Must Have Tool Costs so little yet saves so much in both time and cost of lost drill bits. Get one to always have in your tool box because you will use it one day i guarantee.
Veröffentlichungsdatum: 2015-11-16
Rated 2 von 5 von aus Grub screws kept coming undone The idea to enable me to use the drill bits at full length using the extension arm was a great idea but, the grub screws kept coming loose all the time. From the start the Allen key was found to be a very loose fitting in the grub screws, I tried various other keys that I had but none fitted the screws. After having tightened the screws hard to stop them coming undone again I found that the key would only turn in the screw and I had to drill out the grub screw to get the drill bit out. I will now recut the thread and put in some better quality grub screws that will fit the Allen key.
Veröffentlichungsdatum: 2016-11-22
Rated 5 von 5 von aus Extended drilling It did all I expected of it, gave me the extra length needed, was firm and felt safe drilling a blind hole. It comes complete with allen key to tighten the 2 screws. I am well pleased with my purchase. Marked the reliability down as I have only used it twice, but it does feel quality.
Veröffentlichungsdatum: 2015-02-11
Rated 4 von 5 von aus Useful Very handy when going through large wood sections. I used it to open 32mm holes in a new log cabin. Only thing to watch is to make sure the two grub screws are aligned correctly with the shaft of the flat fit else you might strip the thread and have to get a new one
Veröffentlichungsdatum: 2014-11-05
Rated 5 von 5 von aus Brilliant piece of kit I needed to drill a 7mm diameter hole close to a 200mm upstand. This extension held the small flat wood bit well and made the job so simple. It should also hold screwdriver bits (in a magnetic holder) for hard to reach jobs as well. It will stay in my tool kit!
Veröffentlichungsdatum: 2016-07-29
Rated 5 von 5 von aus Trade quality at DIY price I have used a few like this over the years but this one is the longest and strongest of them all; with strong grub screws to bolt the hex flatbit in place. It's possible to double these up for even longer jobs and as a tip I always re-sharpen flatbits with an angle grinder to extend their life and so that they cut easily and cleanly.
Veröffentlichungsdatum: 2017-08-20
Rated 5 von 5 von aus Reaches the parts other bits.. Needed to drill an access hole for a lighting wire through a joist but without access from either the floor above or ceiling below. Using this extender combined with the Armeg Wood Beaver drill bit bought at the same time I was able to drill a smallish hole (easily filled with a bit of filler afterwards) through the ceiling board and the joist at an acute angle such that I could get cabling rods through to my light fitting spur on the other side. Without this extender I was at a loss for what to do without trashing either the floor above or ceiling below. It holds the hex bits really firmly and those Wood Beaver bits really get on with their job so take it very easy on the drill speed and be sure to check both sides of the joist for pipes and wires with pilot holes and suitable probe. This thing will live in my drill case which at 300mm, fits just right with my DeWalt. It's well engineered from a single piece of quality steel and held on tight to a drill bit that wanted to drill to the centre of the earth given half a chance! The bit is held good and straight.
Veröffentlichungsdatum: 2016-11-27
  • y_2018, m_11, d_15, h_21
  • bvseo_bulk, prod_bvrr, vn_bulk_2.0.9
  • cp_1, bvpage1
  • co_hasreviews, tv_0, tr_39
  • loc_de_DE, sid_9185K, prod, sort_[SortEntry(order=RELEVANCE, direction=DESCENDING)]
  • clientName_screw-fix-de